This post is more than 5 years old
4 Posts
0
148462
August 6th, 2014 08:00
PNTools installl command line
Hi,
I am trying to install the pntools msi as an SCCM application. In out environment, we only want to install the core and the Universal Printer Driver. I have been searching for the documentation on how to achieve that, but have not found any so far. Can someone point me in the right direction?
TIA
No Events found!
umack
4 Posts
0
August 18th, 2014 03:00
Hi,
If you look at the feature list in the PNTools MSI, you see the following features:
USB_IT - USB virtual hub
MMR - WMP redirection
Required_Components - core
DNA - latency reduction (mandatory on WAN) - part of Required_Components
FMMR - Flash redirection
MM_GA - legacy graphics acceleration - part of Required_Components
Metaprofiles_IT - User Profile Management
PNShell - login actions - - part of Required_Components
Print_IT - Universal printer Driver
So to install the core plus UPS, you would need Required_Components and Print_IT
I'm pretty sure (but not 100% certain) that you would need the following:
MSIEXEC /i pntools.msi ADDLOCAL=Required_Components, Required_Print_IT /qn /forcerestart
regards,
Rick
TFelts
4 Posts
0
August 18th, 2014 08:00
Thanks for this. Got me going in the right direction. The command line that appears to be working is
MSIEXEC /i "pntools64.msi" ADDLOCAL="Required_Components,Print_IT" /norestart
A check of the Feature Table (using Orca) revealed that the UPD feature was labelled "Print_IT".
Thanks again.