This post is more than 5 years old
1 Message
0
2066
June 9th, 2017 15:00
CX4-5 Standby Power Supply A
Hi everyone I need a replace the Power Supply but anyone know how it is the procedure for doing so?, I need power off the storage? this change is "hot swap"? this change is online? help me please.
Thank you
No Events found!
kelleg
4.5K Posts
0
June 12th, 2017 12:00
The SPS (Standby Power Supply - battery backup):
Model # Part # Description
AX4-5SPS 078-000-062 1000W SPS qty 1
Additional source of information for AX4
https://support.emc.com/products/7838_CLARiiON-AX4-Series
Also, go to the CLARiiON on-line forum and then click on the AX4 Series selection on the left side for more information on the AX4 topics
CLARiiON
If your AX4 has two SPS, then you can replace on-line - it's hot swap, you must manually disable System Write Cache first (it may already be disabled due to the SPS failure.
Remove the inlet power to the SPS, disconnect the cables to the Storage Processor (one power cable and one sense cable).Remove the failed SPS, install the new SPS, re-cable the power cable to SP and the sense cable, then connect the inlet power to the SPS and power on. It may take some time for the battery to re-charge.
glen