This post is more than 5 years old
32 Posts
0
696
December 3rd, 2015 08:00
info about clone commands
hello
i m resident at a customer that use clone with vmax 20 k , code 5876.272.177 .
customer said that with sycli was not able to see when a clone finish to copy.
do you know if a symcli command exist ? also an inline commands ( not for customer ) but for me so i can monitor the start -end of a clone copy ?
thanks
giacomo
No Events found!
umichklewis
3 Apprentice
•
1.2K Posts
0
December 3rd, 2015 14:00
You can use the SYMCLI command "symclone -g verify -copied" to confirm the state while the clone is being established. When completed, the command will return the clone has been copied.
Other commands, such as "symclone -g query -summary" will also show the state of the device during the copy. If you add "-i " it will report every X seconds, and will show progress and expected completion time.
Let us know if that helps!
Karl
jeka1
32 Posts
0
December 7th, 2015 03:00
thanks to all ! many useful !
regards
giacomo
jeka1
32 Posts
0
December 7th, 2015 06:00
hello sorry
lust question fo rme..
there are also inlines commands from symmwin to check the duration of a clone copy ?
thanks again in advance
cester giacomo