Start a Conversation

This post is more than 5 years old

Solved!

Go to Solution

696

December 3rd, 2015 08:00

info about clone commands

hello

i m resident at a customer that use clone with vmax 20 k , code 5876.272.177 .

customer said that with sycli was not able to see when a clone finish to copy.

do you know if a symcli command exist ? also an inline commands ( not for customer ) but for me so i can monitor the start -end of a clone copy ?

thanks

giacomo

3 Apprentice

 • 

1.2K Posts

December 3rd, 2015 14:00

You can use the SYMCLI command "symclone -g verify -copied" to confirm the state while the clone is being established.  When completed, the command will return the clone has been copied.

Other commands, such as "symclone -g query -summary" will also show the state of the device during the copy.  If you add "-i " it will report every X seconds, and will show progress and expected completion time.

Let us know if that helps!

Karl

32 Posts

December 7th, 2015 03:00

thanks to all ! many useful !

regards

giacomo

32 Posts

December 7th, 2015 06:00

hello sorry

lust question fo rme..

there are also inlines commands from symmwin to check the duration of a clone copy ?

thanks again in advance

cester giacomo

No Events found!

Top