This post is more than 5 years old
4 Operator
•
2.1K Posts
0
910
March 31st, 2010 06:00
Setting the "auto_link_recovery" flag on an RDF group after it is created
I've run into a bit of a snag which doesn't seem to make a lot of sense to me. I do have a work around, but I'm curious if anyone knows what I'm missing here...
I have a pair of DMX3 arrays running Enginuity 5773. I have a management host running SE 7.1 and SMC 7.1 I have an RDF group that I created to migrate some devices to that will only be running in ACP_Disk mode (not really relevant I guess). When I created the group I forgot to specify "disable" for the "Prevent Auto Link Recovery" flag (the mainframe guys don't like this on for their stuff). Now I can't find any way to change the setting on the group without deleting and recreating it. I've been through SE & SMC with a fine tooth comb and I just can't seem to find a way to do this.
Anyone have any thoughts, wisdom, or references to the documentation which I have overlooked?
dynamox
9 Legend
•
20.4K Posts
0
March 31st, 2010 07:00
Allen,
take a look at the bottom of this solution emc112799
Allen Ward
4 Operator
•
2.1K Posts
0
March 31st, 2010 07:00
OK, I'm not sure why that one didn't come up for me when I searched, but it seems pretty clear. I guess I fall back to my workaround of recreating the group from scratch :-(
Thanks dynamox!
dynamox
9 Legend
•
20.4K Posts
0
March 31st, 2010 07:00
this is kind of odd though ..you would expect everything that has been created dynamically ..can be modified dynamically as well?
Allen Ward
4 Operator
•
2.1K Posts
0
March 31st, 2010 08:00
I thought the same, but was very surprised when I couldn't find any way to modify this setting. In this case you can't even modify it through a BIN load since it is a dynamic group!