Idrac 8 and 9 -SNMP Agent - Enable SNMPv3 only using RACADM

Question

Hi as the title says, i just need to set the agent to SNMPv3 under the services page.
I need to do this Via RACADM as i will be sending commands to multiple idracs.

In the below image you can see its set to all:
i need just SNMPv3

Thanks in advance

DELL-Marco B · Accepted Answer

Hello, you can check here another similar conversation ‎RACADM Command to set snmpv3 Protocol | DELL Technologies   Thanks

Keith Sherwood · Answer

Excellent, that worked. Thanks for the reply.

PowerEdge OS Forum

Idrac 8 and 9 -SNMP Agent - Enable SNMPv3 only using RACADM

Was this post helpful?