PowerEdge R515 can't see SAS disks after switch H700 to H200

Hello,

I am working on a Dell PowerEdge R515 where the provided PERC H700 has been switched with an H200.

When the H700 is installed, the utility correctly sees the enclosure disks (2x SAS) and the frontal disks (2x SATA and 10xSAS). There are no virtual disks nor foreign configurations.

When switching to the H200, the configuration utility only shows the 2 enclosure disks and the frontal SATA disks. The 10 SAS frontal disks are not shown. I tried to remove the SATA disks and the result is the same (in this case only the enclosure disks are shown).

Any suggestion on how could I use all the disks in the machine front? Using the H700 is not possible as it does not allow for JBOD/passthrough and the machine should be used for tests with ZFS. The same swap has been done on another machine without issues.

Thanks in advance