Interaction between route-map and access-group on powerconnect vlan

Hello JSL2,

Thank you for choosing Dell.

Did you try to apply follow command:

console(config-route-map)#set interface null0

PBR does however provide a way to drop a packet if desired. By using the set interface null0 command, users can drop any packet that matches the criteria on a permit statement. Simply add the following set statement to your permit sequence.

Source:

https://dell.to/323eMjj  p.20

Please ask me if you have any questions.

Maria Januszka

#IWork4Dell

Dell | Social Outreach Services - Enterprise

No I haven't tried the command yet. I'm going to wait until non-business-hours. This device is not under support unfortunately.

Hello  JSL2, 

Thank you for your reply. Did you already try to apply this command? 
I would also like to recommend you contact phone support, if you have active warranty, because support can check logs and also could check the configuration. 

Thanks, 
Maria Januszka 
#IWork4Dell
Dell | Social Outreach Services - Enterprise

Ah ok, so the idea would be not to use ip group-access at all, and just put all of the port restricting/firewalling into the PBR?

Since you cannot use a match statement on a route-map with the set interface null0, how would you actually implement a rule that blocks access to a specific network?

!-- What the DMZ hosts are allowed to access on the LAN
route-map "dmz-map" deny 10
     Match clauses:
       ip address (access-lists) : dmz-lan-allowed
     Set clauses:

!-- select hosts routing out 2nd ISP
route-map "dmz-map" permit 20
     Match clauses:
       ip address (access-lists) : dmz-twc-outbound
     Set clauses:
       ip default next-hop 172.27.12.3

!-- MAGIC PERMIT/DENY 30 RULE

!-- the default packet dropper. I need to add a "match" to this to only
!-- drop dmz-lan-denied, but I can't put a "match" on this.
route-map "dmz-map" permit 40
   Match clauses:
   Set clauses:
       interface null0

I would need to implement a deny 30 that matched everything that wasn't the in dmz-lan-denied ACL. How would I do that?

ip access-list dmz-lan-denied
1000 permit ip 172.27.3.0 0.0.0.255 172.27.9.0 0.0.0.255
1010 permit ip 172.27.3.0 0.0.0.255 172.27.10.0 0.0.0.255
1020 permit ip 172.27.3.0 0.0.0.255 172.27.15.0 0.0.0.255
1030 permit ip 172.27.3.0 0.0.0.255 172.27.30.0 0.0.0.255
exit

Hello JSL2, 

Thank you for your reply. May I please ask you to provide Service Tag and location of the switch in Private Messages? I would like to contact colleagues from Networking Team and I need this information.

Thanks, 
Maria Januszka 
#IWork4Dell
Dell | Social Outreach Services - Enterprise

I PM'ed you that information

Well, thanks for the response anyway!