5 Posts
0
722
September 25th, 2020 05:00
Auto Stack-Unit Configuration?
Hi, after I have changed the IP of my switches I have the problem that my stackunit (containing two S4810 force10 switches) are not both in management mode after a reboot. One is always in standby mode and I need to use ssh-peer-stack-unit command to fix it. Furthermore he asks me for login data, which was before not the case. How can I enable an auto-stack-unit configuration? I already tried "redundancy synchronize full", but this doesn't help. Thanks in advance.
No Events found!
DELL-Josh Cr
Moderator
•
9.2K Posts
0
September 25th, 2020 09:00
Hi timejason,
So neither switch is in master mode? You may want to try to remove the stack and recreate it. Page 955 https://dell.to/3053Ai3
timejason
5 Posts
0
October 8th, 2020 03:00
Hi,
so I found out that I've done everything correct. The stacking was fine and one switch was in master mode while we other one was in standby.
After I have plugged in some network cable into the standby switch I saw that on the master node it recognised it.
Anyway thanks for your answer.