3 Posts
0
920
December 28th, 2022 10:00
802.1x for N1148 Switch
I've gone through and attempted to setup RADIUS, but when i plug in a device, the switch never reaches out to my NPS server.
Any help would be great.
!System Software Version 6.7.1.17
ip address 192.168.19.8 255.255.255.0
exit
ip default-gateway 192.168.19.1
username "admin" password privilege 15 encrypted
dot1x system-auth-control
radius server source-ip 192.168.19.8
radius server auth 192.168.140.4
primary
name "DC02"
key 7 " "
exit
interface Gi1/0/10
no green-mode energy-detect
no green-mode eee
switchport mode general
switchport general allowed vlan add 500 tagged
switchport access vlan 140
authentication host-mode single-host
authentication event fail action authorize vlan 100
authentication periodic
exit
!
No Events found!
BradyNext7
3 Posts
0
January 3rd, 2023 05:00
Thanks for the follow-up. I found that it wasn't a firmware issue, it was a reboot problem. After rebooting the switch, 802.1x started working. All ports are set to do Radius, it locked out all my ports when I rebooted. Consoled in, updated a single port for management and we were off to the races.
DELL-Young E
Moderator
•
5.1K Posts
0
December 28th, 2022 21:00
Hi could you bring your firmwares up to date?
Dell Networking N1100-ON Series, Firmware Version 6.8.1.0
Dell EMC Networking N1100-ON Series Firmware version 6.7.1.20
https://dell.to/3C3rHkr
BradyNext7
3 Posts
0
December 29th, 2022 05:00
Can do. Is the current version just broken, or is it more preventative?
DELL-Charles R
Moderator
•
4.4K Posts
0
December 29th, 2022 08:00
Hello BradyNext7,
As a first step of troubleshooting we like to have firmware updated to make sure we're not troubleshooting an issue that may have been resolved in a firmware update.