This post is more than 5 years old
14 Posts
0
1435
July 25th, 2012 10:00
Which version of CLARiiON supports IPv6 and which NaviCLI to be used with it?
Hi All,
I have the following question -
- Which version of CLARiiON supports IPv6 and which NaviCLI to be used with it?
- Can I configure IPv4 as well as IPv6 IP addresses on CLARiiON?
- Can I install & run Navi CLI from a host with IPv4 & IPv6 IP address?
Thanks,
Sushobhan
No Events found!
rupal1
433 Posts
0
July 26th, 2012 06:00
All the CX4 series of clariion supports IPv6. Naviseccli link is provided by Ankit here.
The management ports support both IPv4 and IPv6 Internet Protocolsconcurrently. IPv4 is the default and you must provide IPv4 addresses.If your network supports IPv6, you can choose to use IPv6 withautomatic or manual configuration. For automatic configuration, youdo not need to provide any information. For manual configuration, youmust provide the global prefix and the gateway.
No both cannot be configured simultaneously as per my knowledge.
Not with both simultaneosly.
Thanks
Rupal Rajwar
AnkitMehta
1.4K Posts
0
July 25th, 2012 10:00
CLARiiON CX4 Family Support IPv6. Using latest version of NaviCLI is always recommended.Navisphere CLI (Windows - all supported 32 & 64-bit versions) 7.32.0.5.54
If you do not specify the IP address (either IPv4 or IPv6), then by default IPv4 information is displayed. The default IP address is IPv4. If the IPv4 and the IPv6 are specified, the information is displayed for both IP addresses with the IPv4 information listed first.
sushobhan
14 Posts
0
July 26th, 2012 06:00
Thanks Rupal
Regards,
Sushobhan
rupal1
433 Posts
0
July 26th, 2012 06:00
Anytime Sushobhan...Keep posting
sushobhan
14 Posts
0
July 26th, 2012 07:00
Thanks Ankit
Regards,
Sushobhan
AnkitMehta
1.4K Posts
0
July 26th, 2012 15:00
1. Which version of CLARiiON supports IPv6 and which NaviCLI to be used with it?
IPv6 support came out at Release 28. (FLARE)
Initially, the goal was
- IPv6 access to management port
- Support Stateless configuration of IPv6 address for array management port (GUI IPv6 addresses read-only)
- CIMOM (Management Server) to listen on both IPv4 and IPv6 addresses Client can manage array via IPv6 address in browser.
- NaviSecCLI to support IPv6... and many more!
2. Can I configure IPv4 as well as IPv6 IP addresses on CLARiiON?
There!
3. Can I install & run Navi CLI from a host with IPv4 & IPv6 IP address?
Yes, but since IPv6 usage in industry is not as it should be, at present it would be IPv4 in case both is configured which might get sorted in future!
i.e.
IPv6 to IPv6, Yes!
IPv4 & IPv6 will be IPv4.
sushobhan
14 Posts
0
July 29th, 2012 23:00
Thanks again Ankit for the detailed info. This helps a lot.