This post is more than 5 years old
1 Rookie
•
100 Posts
0
1454
August 10th, 2012 09:00
Physically relocate SPE and DAEs on CX4 480?
Hello,
I have physically to relocate DAEs.
We have to move Clariions to other room.
This the plan:
1.Power off all host and fc switches.
2.Power off procedure on each clariion one by one.
3.Deattach all PDUs and power cable.
4.Move parts to new location.
5.Install SPE and all DAEs on new racks and set the same IDs and loops.
6.Power up procedure
The main question is- all raid group and luns will be on place after power up clariions?
No Events found!
dynamox
9 Legend
•
20.4K Posts
0
August 10th, 2012 09:00
as long as you cable everything identically, then yes
Anirudh_Banerje
59 Posts
1
August 10th, 2012 09:00
Hi Angel,
Yes, there should not be any impact with CLARiiON RAID groups and LUNs which are created there in the array, with the power-on procedures.
For more information on power-on/ power-off procedures for CLARiiON, please refer the primus article# emc252999
from powerlink.
Thanks
Anirudh
angel_isakov
1 Rookie
•
100 Posts
0
August 10th, 2012 10:00
Thank you very much.
The main problem is that i have 2 clariion in 4 raks:
Clariion 1 with one rack for SPE and DAEs and one rack only with DAEs.
Clariion 2 with one rack for SPE and DAEs and one rack only with DAEs.
I will easily move the whole rack with SPE, but have to disconnect rack with DAEs, move both to other room and connect all again- every DAE on the same BUS and the same Encl ID.
May be other option is to remove all disk one by one, but i don't have empty DAEs
dynamox
9 Legend
•
20.4K Posts
1
August 10th, 2012 10:00
don't do that, keep it simple. Carefully label everything, preferably with different colors so you know what goes where. You should not be changing anything (no bus, no nothing ! Reconnect everything just like it was before the move.
Message was edited by: dynamox