Unsolved
This post is more than 5 years old
1 Message
0
4244
May 18th, 2015 08:00
Wyse X90C7 PXE Boots fails at F12 Command
Wyse X90C7 PXE Boots fails at F12 Command
Hello Guys,
I am attempting to build the X90C7 via the PXE method using SCCM 2012 R2. The network card is being recognised and DHCP is allocating the appropriate IP address. It runs correctly through the request sequence and presents the F12 option.
Pressing F12 achieves nothing and it just sits there. I also tried an external keyboard just in case but again the same results.
Any help greatly appreciated.
No Events found!