Unsolved
This post is more than 5 years old
3 Posts
0
21109
May 18th, 2015 08:00
D90D7 - BSOD after pushing an image to another device
D90D7 - BSOD after pushing an image to another device
USB Firmware tool 1.20.0.1
I have a problem where I have pulled an image from one device and pushed it to another. On restart the newly imaged device begins to load Windows 7 then gives a stop 7b error. As far as I can see both devices are D90D7 16GMF/2GR SO so would expect the hardware to be the same.
I flashed the new device back to factory and tried again, I also pulled another inage from the source device but have the same problem. Any ideas if I've done anything wrong? I did some registry lockdowns and installed office on the terminal but it looks more hardware related to me.
No Events found!
mrzoops
1 Message
0
May 18th, 2015 08:00
Same exact thing happening to me. I recall this being a setting in the bios when I did a batch of flashes months ago, but I cannot figure it out this time. Did you figure it out?
Stevo532
3 Posts
0
May 28th, 2015 04:00
Not yet however having spoken to Wyse support it seems I probably have to run through a sysprep process on the device before extracting the image. Its apparently part of the wdm process but instead of putting the image on the server you push it to the usb drive. Not tried it yet.