Unsolved
This post is more than 5 years old
1 Message
0
5048
July 3rd, 2015 01:00
Wyse V30L(902139-0XX), USB Tool and/or WDM 4.9.1
Wyse V30L(902139-0XX), USB Tool and/or WDM 4.9.1
I recently purchased 18 Wyse V30L terminals off Ebay - all are functional, but have no OS on them.
I have a 30 day trial of WDM 4.9.1 but that does not recognize anything and will not load them.
So, I bought one more V30L with an intact OS, and I attempted to use the USB tool to pull from it.
That does not work either.
How do I reload the stock WinCE 5.0 (or 6.0) on these so I can use them? I have dozens of older models that are workhorses, I just need more for expanding remote locations.
No Events found!
RustyMonkey
96 Posts
0
July 3rd, 2015 01:00
bhoffman,
since the V30L have no OS, and are already a retired model, you will need to use WSI to re-image them. You can find WSI and the firmware for the v30L at www.wyse.com/downloads under the retired section. MAKE SURE YOU ALSO DOWNLOAD THE MANUAL FOR WSI AND READ IT. YOU MUST FOLLOW THE INSTRUCTIONS AS THEY ARE WRITTEN OR THE RE-IMAGING WILL NOT WORK.
Good luck