Unsolved
This post is more than 5 years old
2 Posts
0
9301
May 20th, 2015 09:00
USB FT 1.18 push/pull not working on V90LEW
USB FT 1.18 push/pull not working on V90LEW
I set up one system and would like to replicate it on another. I run the firmware tool, set up the USB drive, restart, go through the pull program, etc. Everything looks like it runs properly but the image file saved is only 16mb. When I run the push program on the blank Wyse, it also appears to run properly but when booted, nothing has changed.
Any ideas? Thanks
No Events found!
phenton
2 Posts
0
May 20th, 2015 09:00
I think I am being retarded. Now that I realize that this tool only transfers firmware and not the entire drive contents, what is the quickest/easiest way to copy and transfer the entire drive image between terminals?
furqan-2015
1 Message
0
May 28th, 2015 08:00
Nice surprise about this shorter form. Can you tell us what it is you are talking/writing about?
Has any info. about this shorter form been posted before (and i just missed it)?This is really helpful for me because i was also looking for this.
Regards
learn-french learn french in france
pimsleurapproach pimsleur language - pimsleurapproach.biz
envisionwebhosting envisionwebhosting.com - cheapest website hosting
testinside testinside