V10LE Firmware or Reset

Question

Have inherited quite a few legacy V10LE Wyse terminals (Pre Dell) that we use within our company. I understand these devices are no longer officially supported but the Firmware files for them must exist somewhere. Where can legacy firmware files be downloaded/acquired? A call to Dell Support directed me to this forum for support (after I could not give them a service tag) for these devices. I am hoping there is a way (We have done it before) that I can pull the OS files off one of our working clients and Push them onto one of the ones we purchased that has some sort of custom version on it.

If the firmware can't be found, is there a way to factory reset them? I tried the holding 'G' and since they require me to enter an ADMIN code, I can't use the 'Restart to factory' Checkbox either.

Any help anyone can give me would be appreciated.

Robb Feldhege

IT Manager

Becker Furniture World

doge guide · Answer

open them up and then on the right side of the cmos battery is a header and it should be in default position (look below for position) and if it isn't then it shouldn't do anything and you'll just have to move the red jumper to the default position and then when it asks u 4 a password u type "Fireport" as the password

but if they're not in reset position already then put them on it then put them back on default position then boot them up and do the same stepsreset positiondefault position

Wyse ThinOS

V10LE Firmware or Reset

Was this post helpful?