Could we use Link Aggregation for the network cards and ports added in VxRail?

Hi,

Would you like to let me know about whether we could use Link Aggregation for the network cards and ports added in VxRail?

As we know, all node types support adding additional network cards like the link below, excluding the G-Series. It seems that the cards added can be used with Link Aggregation if it is based on VMware’s official instructions/procedures.

・DELL EMC VXRAIL APPLIANCE_Techinical FAQ

https://www.emc.com/auth/rcoll/faq/vxrail-4-faq-tech.pdf

Q: Can I add additional networking capability for my VxRail 4.0 appliance?

A: Yes, all node types, excluding the G-Series 2U4N hardware, support adding additional 10GbE PCI-e network cards for networking port expansion. These additional ports are considered Optional Connectivity……

Actually, I just concern about the description in the DELL EMC VxRAIL NETWORK GUID like below.

・DELL EMC VxRAIL NETWORK GUID_

https://www.emc.com/collateral/guide/h15300-vxrail-network-guide.pdf

Disable Link Aggregation

Do not use link aggregation, including protocols such as LACP and EtherChannel, on any ports directly connected to VxRail Appliances. VxRail Appliances use active/standby configuration (NIC teaming) for network redundancy, as discussed in the section on Network Traffic.

Best regards,