This post is more than 5 years old
53 Posts
0
4638
June 26th, 2012 06:00
Suspended distributed device
Hi
I have a problem with a distributed device in VPLEX. If I check the status of the Distributed Device in the CLI it says:
summary:: suspended, details:: [requires-resume-at-loser]
However, when I execute "resume-at-loser", I get the following output:
consistency-group resume-at-loser: Evaluation of < > failed.
cause: Failed to resume I/O at cluster cluster-X in consistency-group 'XXX'.
cause: Firmware command error.
cause: Property is not awaiting resume.
Can anyone help me please?
Thanks
No Events found!
zgz_rever
53 Posts
0
June 27th, 2012 05:00
Found the solution!
Even though the consistency groups are distributed across both clusters, they are always created in one of them. The cosistency group must be "resume-at-lose r" in the cluster where the consistency group was created. Stupid behavior but that is the only way to make it work.
I hope I help someone in the future
Menno
1 Rookie
•
29 Posts
0
August 30th, 2012 08:00
Distributed devices wil also go suspend in à consistency group if you powerdown one cluster in à metro config. When is involved and i/o gets to the "winning" cluster, you have to manual do the resume at loser command....