This post is more than 5 years old
6 Posts
0
1076
December 20th, 2016 10:00
Add DAE to VNX5300
I found some older community articles but most go to dead links. I have tried to search the support site and so far I have not been able to find what I am looking for. It has been a few years since I have been part of adding a DAE to a VNX. I want to make sure I don't skip over any steps so I am working on documenting the process before I go forward with it. Does anyone know where I can go to get good documentation of all the steps required when racking, cabling, and adding new DAEs to a VNX 5300?
No Events found!
umichklewis
3 Apprentice
•
1.2K Posts
0
December 21st, 2016 05:00
You can always visit https://mydocs.emc.com and use the VNX series link. THis contains procedure generators for adding DAEs and so on.
Let us know if that helps!
Karl
will2451
6 Posts
1
December 21st, 2016 07:00
Thanks for this. I had tried it and it kept not working so I just assumed it was no longer a good link. I went ahead and tried again after your post and it looks like it is working just fine now and I was able to get the info I was looking for!