Skip to main content
Start a Conversation

Unsolved

S

sabit

14 Posts

396

February 14th, 2023 02:00

SAN Copy Pull from SC9000 (FC). WWN not found

I am trying setup SAN Copy Pull on Unity XT 380 to migrate LUNs from SC9000. I have created two zones each for Port 5 of SPA and SPB, then added SC9000 WWN to each. None of the storages can discover other's WWNs and I cannot create Host entry on SC9000 for this reason.

Do I need to give any uemcli command to expose SP ports to SC9000? 

Also, is SAN Copy Pull license sold separately? How can I check if this feature is included in this unit?

DELL-Sam L

Moderator

 • 

7.5K Posts

February 14th, 2023 11:00

Hello sabit,

San copy pull is already licensed on your unity system. Since you are using FC Have you done the steps listed in this kb. https://dell.to/3E70ezh

sabit

14 Posts

February 15th, 2023 01:00

I tried to issue the command to delete iSCSI paths, but the output of the following command is empty (no iscsi path running?):

06:28:09 service@DC-Unity380-DEXXXXXXX spb:~/user# uemcli /remote/iscsi/connection show
Storage system address: 127.0.0.1
Storage system port: 443
HTTPS connection

Do I need to run any other command?

DELL-Sam L

Moderator

 • 

7.5K Posts

February 15th, 2023 07:00

Hello sabit,

Are you using this guide to perform your migration? https://dell.to/3K5f8db

sabit

14 Posts

February 19th, 2023 00:00

Hi Sam,

 

Yes I am following that guide. Unfortunately the FC section is very sparse on details. Can you please clarify, if the Unity WWNs are immediately visible to SC9000 after zoning? Or are they exposed after session is created?

DELL-Sam L

Moderator

 • 

7.5K Posts

February 20th, 2023 10:00

Hello sabit,

You should see the WWN once the session has been created.

Was this post helpful?

View All

No Events found!

Top