Dell PowerEdge 7625 Firmware Update TPM Problem

Hello, we just bought our server. I want to do Firmware Update via Lifecycle Controller by following the Dell Installation steps. However, I get a message about TPM as below. How should I manage this process? I want to update the hardware that needs update before my Redhat 8.7 installation. I can update it directly? But if I do this, will it cause problems? All I want to do is firmware update. Or should I turn off the TPM and update?

Thankyou for support.

It is detected that the Trusted Platform Module (TPM) is enabled with pre-boot measurement. It
is possible that BitLocker protection is enabled on the system. When BitLocker protection is
enabled, updating following components will require that a recovery password is entered or a
USB drive that contains a recovery key is inserted during the next system boot.

 

1. Dell EMC iDRAC Service Module Embedded Package v5.1.0.0, ADO

2. Mellanox ConnectX-6 LX Ethernet Adapter Firmware

3. Mellanox ConnectX-6 LX Ethernet Adapter Firmware

4. BOSS-N1 Monbolithic Firmware

5. Dell PowerEdge Express Flash Ent NVMe PM1733a/35a AGN Firmware Maintenance
Release

6. Dell PowerEdge Express Flash Ent NVMe PM1733a/35a AGN Firmware Maintenance
Release

7. Dell PowerEdge Express Flash Ent NVMe PM1733a/35a AGN Firmware Maintenance
Release

8. Dell PowerEdge Express Flash Ent NVMe PM1733a/35a AGN Firmware Maintenance
Release

9. Dell Express Flash NVMe PCle SSD CM6 Firmware Release

10. Dell Express Flash NVMe PCle SSD CM6 Firmware Release