Unsolved
This post is more than 5 years old
6 Posts
0
945
January 20th, 2015 02:00
Shall we use same LUN for SRDF and RecoverPoint replications ?
Hi,
We have Symmetrix Arrays in primary and secondary locations and currently using SRDF for remote replication.
Client is now planning to migrate from SRDF to RecoverPoint for Remote replications.
My first query, can we use the same LUN for both SRDF and RecoverPoint replications ?
Could some one also please provide if you have any sequence of steps for migrating SRDF to RecoverPoint.
Thank you in advance.
No Events found!
Ugin
1 Rookie
•
122 Posts
0
January 20th, 2015 03:00
Moving from SRDF/S to RecoverPoint
Source device can be same for SRDF and Recoverpoint, however the target device should not be the same.
taz_at_emc
54 Posts
1
January 20th, 2015 03:00
When it comes to SRDF - The R2 device, which is the DR device will get into write disabled state. Where as in Recoverpoint - the DR device will also be in ready state but we cannot use it to mount it on the host.
Am hoping someone will have steps for the SRDF to RP document.