Unsolved
This post is more than 5 years old
12 Posts
0
458
October 19th, 2011 11:00
Finding Luns in SPA
I have been trying to find a way to determine which Luns are zoned to a particular FA in SPA. Is there a way to do this?
No Events found!
Unsolved
This post is more than 5 years old
12 Posts
0
458
October 19th, 2011 11:00
I have been trying to find a way to determine which Luns are zoned to a particular FA in SPA. Is there a way to do this?
Top
Allen Ward
4 Operator
•
2.1K Posts
0
October 19th, 2011 12:00
Agreed dynamox. SPA is not the place to find that info. You need to dig it out of SMC before you go into SPA (or after if you are tracing down the impact of a performance issue you find). CLI will do it as well, but if you are already in SPA I'm assuming you are "close" to SMC.
dynamox
9 Legend
•
20.4K Posts
0
October 19th, 2011 12:00
Not sure what you would see in SPA, you need to look in SMC or from the command line (symcfg list -sid -dir 8a -p 0 list -address)
Fenglin1
4 Operator
•
2.1K Posts
0
October 19th, 2011 20:00
if you need see the LUNs mapped on particular port on FA. following CLI is available for this.
symcfg list -addr -avail -sid -fa 7f -p 0
sullysam1
12 Posts
0
October 20th, 2011 05:00
I was hoping that there was a way to find out which lun on a particular FA was the busiest.
dynamox
9 Legend
•
20.4K Posts
0
October 20th, 2011 06:00
You will need to group devices from a particular fa into a device group and then use spa / symstat to look for whatever metrics you need