Skip to main content
Start a Conversation

Unsolved

This post is more than 5 years old

lineman3

23 Posts

794

July 22nd, 2009 06:00

Unable to run ETL after migrating XMLREPOSITORY

After migrating the storage scope xmlrepository, when I try and run the ETL again, first, on the ETL web page, it states in "red" that it can't connect, and when you try and run it again, it fails with "not enough memory on host to perform operation".

Please note: the ETL worked fine after the 6.1 upgrade, but not after the migration.

Thanks.

lineman3

23 Posts

July 22nd, 2009 07:00

None, the migration appeared to run as intended.

Thanks.

DavidSpencer

11 Posts

July 22nd, 2009 07:00

I don't know if there are any known issues regarding memory usage and ETL (hopefully someone can lend some insight there).

Were there any indications of problems with the XML Migration Utility?

AnuShivnath

41 Posts

July 22nd, 2009 08:00

This is the first time that such a case has been reported. XML Migration utility runs in the same JVM as ETL. There are a couple of things you can do before you log a ticket with engineering to see if the problem gets resolved.

Restart the WebServer service on the StorageScope host.
Check if there is any available disk space left over, if you migrated a huge amount of data it might have eaten up all your disk space.

If the above does not help, please open a ticket with all the log files under /srm/logs.

lineman3

23 Posts

July 23rd, 2009 10:00

I reverted back to a state prior to running the migration; I ran it again, and it worked as intended, so I just not going to worry about it for now. Thanks.

Was this post helpful?

View All

No Events found!

Top