R2 status for mapped devices are RW in properties view (ECC)

Hi all,

Is there anybody which have observed that R2's have the status RW in the properties view for dynamic pairs ?
Im quite sure that the column for status have been changed from "Device Status" to "Device SA status" sometime...
It's not a problem just cosmetic, but it's little confusing as normally should the R2 be WD until a failover.
We have a mix of RW and WD for R2's as the status are changed to WD when failover and swap are executed.

ECC (Properties view)
Symmetrix Lun Name ID Label Status
000290300xxx 101 101 RW

SMC
Dev Dev Config Cap (MB/Cyl) Dev Status
0101 RDF2+R-5 (3+1) 17263/18414 Write Disabled

CLI
C:\>symdev -sid 590 show 101
......
Device Status : Write Disabled (WD)
Device SA Status : Ready (RW)
.....

ECC 6.0 (.650) & and (.607)

Regards Anders