Unsolved
This post is more than 5 years old
41 Posts
0
531
August 1st, 2008 07:00
QUESTION ---> Master Agent - Cluster Support
I have a 4 node cluster ( 3 active / 1 Passive ) and was reading the "Planning and installation guide for ECC SP5). It says agents are supported in a clustered environment and then right below there is a heading that says, "Understand MSCS cluster support for ControlCenter" and inthat section it says only active / passive clusters are supported and only two node cluster are supported for Control Center.
The question is are they talking about the agents or control center as the server software. I just want to be sure. Again I just want to install master agents on all my nodes in the cluster. Thanks in advance.
Message was edited by:
lunz
The question is are they talking about the agents or control center as the server software. I just want to be sure. Again I just want to install master agents on all my nodes in the cluster. Thanks in advance.
Message was edited by:
lunz
No Events found!
StephenKebbell-
12 Posts
0
August 4th, 2008 23:00
I think it means for the control center server software. We have agents installed on all cluster nodes. Works fine, although reporting is a bit confused, as the same disks are allocated to several servers. Instead of counting the disk once, I think it counts it once for each node.
Regards,
Stephen
lunz3
41 Posts
0
August 5th, 2008 07:00