Unsolved
This post is more than 5 years old
6 Posts
0
796
February 2nd, 2011 21:00
Discovery Errors after moving to External poller group
Hi,
Some of devices in APM were discovered and polled. Later on these devices were moved to External polling group. After moving them to external polling group still we are receiving errors related to discovery on SAM console.
When I had checked the Switch Object in the APM,it is part of only External group and the Last DiscoveredTime is very old . Please help in clearing the DiscoveryError manually in APM.
Regards,
Praveen Bajaj
No Events found!
bkuhhirte
52 Posts
0
February 7th, 2011 12:00
Praveen,
Admittedly I am a little lost of the usefulness of your configuration, but there are probably two ways to deal with that problem:
1. Fix the fundamental reason why the device is failing discovery to begin with
2. Turn off periodic rediscoveries of the whole topology and write a utility to rediscover only specific devices
You could change the attributes that drive the event computation, but that will only be temporarily helpful - the next discovery cycle will likely produce the same event again.
Regards,
Bill