Unsolved
This post is more than 5 years old
7 Posts
0
272
April 7th, 2008 23:00
Is there a way to control (on a per class basis) what IP used to poll agent
I have an agent that reports 7 addresses in IP-MIB::ipAdEntAddr table, and the first entry in the table is *not* the address in the seedfile for that device.
SMARTS seems to device to use the first address in that to communicate with the device after walking this table, rather than the configured address.
Of course we could ignore the other addresses - but that doesn't seem right ...
Is there a way to control which address the rest of the discovery and polling will use?
SMARTS seems to device to use the first address in that to communicate with the device after walking this table, rather than the configured address.
Of course we could ignore the other addresses - but that doesn't seem right ...
Is there a way to control which address the rest of the discovery and polling will use?
No Events found!
FredericMeunier_0588be
143 Posts
0
April 8th, 2008 07:00
/opt/InCharge7/IP/smarts/conf/discovery/discovery.conf
AccessAddressFormat
If you are using loopback addresses, they should be use first. If not answer, then, there is a fallback on the other adresses.
--Fred
Frederic Meunier
Solutions Watch4Net Inc
APG & Smarts InCharge integration
http://www.watch4net.com