Unsolved
This post is more than 5 years old
1 Rookie
•
79 Posts
0
701
April 1st, 2008 04:00
acknowledgement
When there is alarm is acknowlegde it does not cleared . I have not added any filter. Is there additional configauration that needs to be done to clear an acknowledged alarm
No Events found!
AdaDie
54 Posts
0
April 1st, 2008 05:00
Do you mean the inactive notifications? If yes you can setup the time in the Global Manager Administration Console in SAM7.1. The value you have to set can be found under ICS Configuration - System Defaults - Inactive Auto Archive Interval.
You have to set the Auto Acknowledge Interval as well. The system will proceed as following.
If the notification will be set to inactive, the auto acknowledge interval will set it to acknowledged after the specified time. It will stay inactive according the time you set in Inactive Auto Archive Interval. After this time the notification will be archived and not shown on the console anymore.
Regards,
Adrian
dele1
1 Rookie
•
79 Posts
0
April 1st, 2008 07:00
What i mean is that a active alarm is acknowledge but fails to clear leaving the screen full of acknowledge alarms
Marsh3
5 Posts
0
April 2nd, 2008 07:00
If you are just looking to hide alarms that have been acknowledged, then you could setup a filter to do this for you.
Just set 'Acknowledged' matches 'No'
Marsh.