Unsolved
This post is more than 5 years old
8 Posts
1
1896
October 7th, 2016 10:00
How to configure VNXe and Cisco switches for ESRS
I know how to add devices in ESRS, but what do I need to do on a VNXe and Cisco switches for them to send errors to the ESRS appliance?
No Events found!
gallom1
22 Posts
0
October 10th, 2016 01:00
About the Cisco switches callhome you need the DCNM (Data Center Network Manager) with a specific callhome license. For the VNXe callhome you should open the Unisphere interface and then select Settings > More Configuration > Alert Settings > ConnectEMC Pane.
Regards
Marco