This post is more than 5 years old
77 Posts
0
373
December 5th, 2007 14:00
Throttle for SAN Copies in RM 5
Hello All,
Every time I set the throttle value in the properties of a SAN Copy session it absolutely never holds. I can set it in the current session and it will stay for the duration of the session, but if I set it in Properties, it doesn't hold. I would at least like to set it to 9 and forget it.
This is very frustrating and any help would be greatly appreciated!
Thanks!
Every time I set the throttle value in the properties of a SAN Copy session it absolutely never holds. I can set it in the current session and it will stay for the duration of the session, but if I set it in Properties, it doesn't hold. I would at least like to set it to 9 and forget it.
This is very frustrating and any help would be greatly appreciated!
Thanks!
No Events found!
JamesBEMC
257 Posts
0
December 5th, 2007 23:00
Where are you setting the throttle? Sounds like in in Navisphere.
If so, that throttle is reset to whatever is configured in the RM GUI (Array properties / advanced) each job the job runs.
Set it in the RM GUI instead - if you using the RM Gui - I recommend opening a SR and we can deal with it for you.
Cheers
James.
drozz
77 Posts
0
December 6th, 2007 06:00