This post is more than 5 years old
6 Posts
0
840
December 8th, 2010 06:00
RP for Migration
Hi:
Customer is using RP just for migration.
Do we still need splitter on the source even though it is juts migration.
Regards,
Gopal.
No Events found!
This post is more than 5 years old
6 Posts
0
840
December 8th, 2010 06:00
Hi:
Customer is using RP just for migration.
Do we still need splitter on the source even though it is juts migration.
Regards,
Gopal.
Top
pozzebom_ezequi
24 Posts
0
December 8th, 2010 07:00
There are several documentation on the powerlink.
Home > Support > Technical Documentation and Advisories > Software ~ P-R ~ Documentation > RecoverPoint
Depending on your environment (splitter or host) you will have special deployment documentation.
I am not aware of any specifically for migrations.
gkbc123
6 Posts
0
December 8th, 2010 06:00
Thanks for the response.
Is there any document cheat sheet, I am basically looking for lessons learned or field experience.
Thanks again.
pozzebom_ezequi
24 Posts
0
December 8th, 2010 06:00
Hi, technically I do not see any problem.
The point is the migration will have to be totally offline, you can not have any I/O to the lun during the initial sync as you do not a splitter.
If you do have the splitter on the source you can do most of the migration online, as all I/Os on the source will be replicated by the splitter, so you would only have to stop the production at the moment of the failover after the initial sync (full sweep) that depending on the size of the lun can take a while.