Unsolved
This post is more than 5 years old
1 Rookie
•
28 Posts
0
1136
December 1st, 2016 11:00
Reverse Replication in Recovery Point (Failover)
Hi Guys,
Reversing the direction of replication permanently (rather than just failing over and failing back) in Recovery Point. (VMAX20k - RECOVERPOINT 3.4)
Presently we are Replicating from Site A to Site B using Recovery Point Consistency Group, instead of using test a copy or something, we would like to Reverse Replicate the Consistency Group (Site B should become Permanently Primary and Site A should be Permanently Secondary).
How would we do it ? (Does Fail over can do this Permanently).
If there is any Document or some thing, kindly share the Step By Step Procedure. Does this have any Down time?
Regards,
JAY
No Events found!
forshr
2 Intern
•
1.1K Posts
0
December 2nd, 2016 00:00
Hi Jay,
Initiating Failover does this permanently.
Regards,
Rich
echolaughmk
2 Intern
•
522 Posts
0
December 2nd, 2016 05:00
In terms of documentation - you should find the process in the 3.4 Admin guide in case that assists you.
jaiii
1 Rookie
•
28 Posts
0
December 5th, 2016 10:00
Hi Guys,
How Many Maximum PARALLEL Copies can we set for Cut over in RecoveryPoint (TEST A COPY AND FAILOVER) at the same time (I heard it's 2 copies can be setup). i Have tested the test a copy and Failover on Test consistency Group (When i Failed over it showed me some options saying mount and unmount.)
After the Faiover Non prod became prod and Prod became Non prod, do we guys have any white paper (I checked the guide it shows follow the procedure.)
Regards,
JAY
forshr
2 Intern
•
1.1K Posts
0
December 6th, 2016 10:00
Only one copy can be selected as only copy can be Production.
Regards,
Rich