Unsolved
This post is more than 5 years old
6 Posts
0
832
December 2nd, 2014 16:00
RecoverPoint VNX LUN state
What should the LUN state be on the destination VNX array. It is showing Ready. Should't it be write disabled like on the VMAX?
No Events found!
brettesinclair
2 Intern
•
715 Posts
0
December 2nd, 2014 17:00
In Unisphere? That's normal.
RP will be holding a SCSi reservation on it, so even if presented to the hosts (by being in applicable Storage Group) the data won't be properly accessible/mountable until one of the image access methods is enabled.
Deb Nelson
6 Posts
0
December 2nd, 2014 17:00
What indicates that it is in a read-only state on the target side?
brettesinclair
2 Intern
•
715 Posts
0
December 2nd, 2014 20:00
Up until at least v4.0, the GUI will show the Replica in the CG as "Storage: No Access". This can also be seen by running get_group_state form the RP cli or admin ssh session. This read/write state is controlled by the splitter/RP.
I haven't verified if this is the same in 4.1, but expect if anything it will be much the same.
Unisphere however, will not show the read/write or access/noaccess state.
forshr
2 Intern
•
1.1K Posts
0
December 3rd, 2014 01:00
Hi Deb,
From an RP perspective is it No Access if part of a CG and attached to a splitter. From an array perspctive it is readable.
Regards,
Rich