Unsolved
This post is more than 5 years old
2 Posts
0
641
March 22nd, 2016 03:00
RecoverPoint "enable image access" on XtremIO
We have replication between two XtremIO arrays, after enabling image access in RecoverPoint for the target side, which LUN do I present to the DR host?
ie. Do I present the Copy (target) LUN, which is the LUN configured as the Copy LUN in the RP Consistency Group, or the Snap LUN of the Copy LUN I can see in the XtremIO? I have tested presenting the Snap LUN to the host and tested perfectly, just not sure that this is the correct procedure.
Regards
Jackie
No Events found!
JackieO1
2 Posts
0
March 22nd, 2016 03:00
Thankyou...
Idan
675 Posts
0
March 22nd, 2016 03:00
Hi Jackie,
You would need to expose the replica volume RP is using and not the underlying snap LUN(s).
Using the snap LUNs would cause many issues as RP cannot undo writes made to directly to the snap volumes.
Regards,
Idan Kentor
RecoverPoint Corporate Systems Engineering