Unsolved
This post is more than 5 years old
8 Posts
0
1434
December 30th, 2015 19:00
Recoverpoint consistency groups being combined in SRM
Using SRM 6.1 with RP 4.1. Have 8 RP consistency groups all configured for external SRM controlled. When I create an SRM Protected Group, it shows only 2 CGs with 4 luns each. I have rescanned the SRA multiple times and still see the same 2 CGs.
I am able to map the CGs to PGs and Recovery Plans and run SRM test.
Thoughts?
No Events found!
echolaughmk
2 Intern
•
522 Posts
0
December 31st, 2015 05:00
This might warrant an EMC SR or Live chat to validate the interop. What version of the SRA are you using? From a review of the support matirx, RP 4.1 is only "supported/qualified" with SRM 6.0, while RP 4.4 is "supported/qualified" with SRM 6.1. BOTH versions of SRM require the 2.2.0.3 version of the SRA so you will want to make sure you are at that level and if not, you can upgrade that and try to rescan or remove/add the RP clusters.
If that doesn't work, it might be an interop issue causing the partial discovery. While the VMware HCL shows a supported interop between the SRM version and SRA, it leaves out the RP version and means that the RP SSM for 4.1 is the official support statement and that shows the following:
MatthewGraci
8 Posts
0
December 31st, 2015 05:00
I am sorry I meant RP 4.4. Brand new RPs with latest version.
echolaughmk
2 Intern
•
522 Posts
0
December 31st, 2015 06:00
Ahh...ok...then that should be supported with the latest SRA version if you have that. If you don't see any changed from removing and re-adding the arrays (RP Site IPs), then it could be something else. Are you at the latest SRA version?