This post is more than 5 years old
5 Posts
0
1076
April 21st, 2009 07:00
Recover maximum lun size
I am using recover point with Clariion CX3 and CX4. The luns originally created on the clariions were created with the box designation as follows: 2 tb. where tb is a check box selection. After reviewing the properties of these luns they show 2048gb. I cannot find a max size for recover point except for 2tb. So my question is will what we have configured work with the RPAs?
No Events found!
cshocke
4 Posts
0
April 21st, 2009 09:00
Tedponczka
5 Posts
0
April 28th, 2009 14:00
The luns originally created on the clariions were
created with the box designation as follows: 2 tb.
where tb is a check box selection. After reviewing
the properties of these luns they show 2048gb. I
cannot find a max size for recover point except for
2tb. So my question is will what we have configured
work with the RPAs?
I was given an answer that according to the documentation it should work however in practice when presenting 2tb (2048gb) luns to the rpa is does not recognize them and serves them up as 0.0 gb.
Tedponczka
5 Posts
0
April 28th, 2009 14:00
The luns originally created on the clariions were
created with the box designation as follows: 2 tb.
where tb is a check box selection. After reviewing
the properties of these luns they show 2048gb. I
cannot find a max size for recover point except for
2tb. So my question is will what we have configured
work with the RPAs?
I just finished RPA classe and in class it was stated 2000gb minus 256 bytes.
RickBrunner1
117 Posts
0
May 2nd, 2009 08:00