This post is more than 5 years old
1 Rookie
•
44 Posts
0
3693
September 1st, 2011 20:00
how to configure RecoverPoint with VNX5300
hi,all:
following my envirment.
four RPA, two VNX5300, two san witch. my plan is construct to CRR .
at site 1 , two RPA, one VNX5300, two san switch. firbrac connect with san switch.
at site 2 two RPA, one VNX5300. RPA to VNX5300 is directly connecting.
my question,
1. frabric cable connection type.
can i do from the VNX5300 SP to RPA ?
2. do the VNX5300 need to install splitter enabler ?
best regards
No Events found!
heidistor
9 Posts
0
September 2nd, 2011 11:00
I just set up the same config last week, except w/o SAN switches as this is an iscsi fabric
1) I direct attached two SP ports on each SP to each RPA at each site. There is a picture, although, not a great one in the Recoverpoint procedure generator.
2) I did install the splitter enabler and it worked fine.
SKT2
2 Intern
•
1.3K Posts
0
September 2nd, 2011 17:00
Any chance you know if this vnx(5100,5300) supports both FCAL and P2P topology?
SureshThirumala
60 Posts
0
November 24th, 2011 18:00
Hello,
Thank you for contacting EMC.
Yes, I do have seen with couple of customers and they have implemented with both FCAL and P2P.
Regards
Suresh Thirumalaisamy
Suresh Thirumalaisamy
Technical Support Engineer
Worldwide Technical Support - IMG RecoverPoint
Office Hours: Sun-Thur, 20:00 to 05:00 hrs EST
Phone : (US Tollfree)1-800-782-4362 || Extn 7633381
Email : Suresh_Thirumalaisamy@emc.com
Please let us know what you think of the level of service provided by sending an email to my manager,
Vashisht, Mohit @ (Mohit.Vashisht@emc.com)
VDA_TECH
1 Message
0
April 9th, 2013 09:00
hi will you please help me in getting Recoverpoint procedure generator.
Thanks in advance.