Getting an error in failover proccess when trying to enable_image_access.

Hi.
I want to expose a problem that we are encountering with RecoverPoint when trying to failover in an installation with only a non-production copy.

From the DR site to the site of the old production (failover has been done previously in the opposite direction, that is, I am now trying to reestablish the situation as if it were the failback process) we're getting an error.
This failover process is being done by CLI for project needs, since it requires giving the commands to an orchestrator.
As it was said, when in this failover process we try to execute the command enable_images_access it gives an error in the parameter "copy" (Error: Invalid 'copy' parameter).
We do not understand what the problem may be, because by GUI, this failover process in both directions is always carried out correctly.
These are the commands that are executed before failover and as you can see the command "enable_images_access" gives an error, previously the group is verified to see its situation with the command "get_group_state".

enable_image_access group=SCLU_MXSS3BUS1001_TEST_IRO copy=TEST IRO image=latest_image access_mode=logged
Error: Invalid 'copy' parameter.
Type 'help enable_image_access' for help with this command.

get_group_state group=SCLU_MXSS3BUS1001_TEST_IRO
Group:
SCLU_MXSS3BUS1001_TEST_IRO:
Enabled: YES
Transfer source: DR_SCLU_MXSS3BUS1001_TEST_IRO
Copy:
DR_SCLU_MXSS3BUS1001_TEST_IRO:
Enabled: YES
Active primary RPA: RPA 3
Storage access: DIRECT ACCESS (marking data)
TEST IRO:
Enabled: YES
Active primary RPA: RPA 3
Journal: DISTRIBUTING IMAGES TO STORAGE
Storage access: NO ACCESS
Max journal size: 1.09 TB
Link:
DR_SCLU_MXSS3BUS1001_TEST_IRO->TEST IRO:
Data Transfer: ACTIVE
Sync mode: NO

We are doing something wrong, but we are not able to see where the error is. Someone who can help us ...

Thank you.