Unsolved
This post is more than 5 years old
6 Posts
0
1159
July 13th, 2017 01:00
Change WAN and LAN on different network adapter to WAN and LAN single adapter
Can you make this change in the cluster modification wizard?
No Events found!
Unsolved
This post is more than 5 years old
6 Posts
0
1159
July 13th, 2017 01:00
Can you make this change in the cluster modification wizard?
Top
Idan
675 Posts
1
July 13th, 2017 02:00
Hi there,
No, for both classic RP and RPVM, this can done only via boxmgmt (assuming the required change is needed after the cluster is already installed. If it's needed during installation - it's configurable via DM in classic RP and Deployer in RPVM).
Regards,
Idan Kentor
RecoverPoint Corporate Systems Engineering
@IdanKentor
radeon187
6 Posts
0
July 13th, 2017 05:00
Thanks Idan!
Yes, this would be for a cluster already installed but not connected to another cluster yet. The customer basically wants to move everything over to thier 10GB SFP+ WAN connections (the physical connections do not exist today but will soon). The cluster is configured with the standard 1gb connections right now. Is there anyway you could provide the instructions on how to preform the conversion via boxmgmt on each RPA? I would image once the configuration is applied, a reboot of each RPA, along with disconnecting the 1gb connections and connecting the 10gb.
Thanks again for responding!
Idan
675 Posts
0
July 16th, 2017 01:00
Sure Shane, are we talking about classic RP here ?
Regards,
Idan
radeon187
6 Posts
0
July 16th, 2017 08:00
Idan,
Yes!
Idan
675 Posts
0
July 17th, 2017 05:00
In that case, assuming the 10Gb SLIC is installed on the GEN6 RPA, just connect cable(s) to the 10Gb ports on the added module and reboot the RPA. Do it one RPA at a time.
Hope that helps,
Idan