Unsolved
This post is more than 5 years old
2 Posts
0
918
April 28th, 2017 07:00
Best Cisco configuration for RecoverPoint/SE
Hello there,
The environment is the Cisco 4500 backbone device. When RP/SEs are running, packets are dropped on the Cisco 4500 backbone.
What is recommended for the Cisco port configuration for RP/SE?
For example mutlicast should be open? What is the best practice?
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 190478
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 2204
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 6336
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 6348
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 7000
0 unknown protocol drops
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 6842
forshr
2 Intern
•
1.1K Posts
0
May 2nd, 2017 07:00
Hi Selim,
The default setting on the eth ports on the RPAs is multicast.
Regards,
Rich
stevDing
3 Posts
0
May 15th, 2017 04:00
By the way , how is your total bandwidth ? Most of this problems happened with poor bandwidth ....
If your total bandwidth is poor ,you may need to increase your bandwidth ...
stevDing
3 Posts
0
May 15th, 2017 04:00
Maybe this will helpful to you :Wireshark Use to Identify Bursty Traffic on Catalyst Switches - Cisco