Unsolved
1 Message
0
305
June 6th, 2023 01:00
No signal problem with Poweredge 440 new installation
Hi,
I wanted to install new storage R440, I prepared the USB to install the sphere on it,
but when connecting the screen on the server, there's no signal on the screen.
I changed the screen and the cables, also I used another VGA port. and restart it without result.
how I can solve the problem??
No Events found!
DellEMCSupport
Moderator
•
631 Posts
0
June 6th, 2023 08:00
Hello awsalawneh,
I could first recommend a flea power drain and check results after:
drain flea power (shut down, disconnect power cables and Network cables, hold in power button 20 seconds with cords removed). After flea power drain, system has to set for 3 minutes for DRAC to reset without any power plugged in, then plug in NIC and power but wait 2 minutes before power on to give DRAC time to initialize.
Are you connecting via iDRAC?
If so: Can you check In the DRAC on Configuration > BIOS Settings > Integrated devices screen > Embedded Video Controller is enabled?
NOTE: If the embedded video controller is disabled in BIOS and if you launch the Virtual Console, the Virtual Console Viewer is blank No Signal.