Unsolved
This post is more than 5 years old
2 Posts
0
26598
September 9th, 2008 12:00
5100Mp picture distortion with red lines using HDMI cable and Playstation 3
Using 19 pin HDMI cable to 5100Mp to Dish 722 Receiver, picture looks fantastic; however, when connected to new Playstation 3 80MB with Tos link audio, picture plays with games and BluRay with a distorted red line in the picture. I can figure out how to change the projector output from 1920 x since it automatically detects HDMI. Any ideas?
TMMcMurray:smileysad:
No Events found!
mpgoff
1 Message
0
September 7th, 2010 15:00
You need to go in and change your output on the PS3. I had the same problem. The problem is that the PS3 is using HDMI so it will default to 1080p output.....which the projector will not prduce a 1080p image. So you have to go into the display settings on the PS3 and make sure that only the 480, 720, and 1080i resolutions are checked. Uncheck the 1080p and you should be good to go.
I had the exact same isses and that was how I resolved it.
Mike