Unsolved

This post is more than 5 years old

4 Posts

11781

July 6th, 2006 22:00

2400mp fuzzy picture

I installed a 2400mp using the ceiling mount  kit and an s video cable going from the dimension 5150 to the projector. At a resolution of 800x 600 and 1024 x 768 I get fuzzy text and picture. I have it set for a 4:3 ratio and have focused and adjusted the size and it will not clear up. I have it mounted about 12 ft from the projection screen. What can I do to clear this up.
 
thanks
kwd

4 Posts

July 7th, 2006 16:00

So I played around with it and found that in 1:1 ratio I get a pretty clear quality. It's not perfect but I can look at it for more than 10 minutes without getting a headache. Now is it the s-video cable that is keeping the 4:3 ratio from being clear. I wanna get the clarity at least as good as I have it now using 4:3. Which cable should I use and keep in mind the projector is mounted about 20ft from the PC.

 

Thanks

Kris

4 Posts

July 12th, 2006 11:00

Still looking for answers. I am getting pretty frustrated with the picture quality. I need to know if its the projector, cable, or card that needs to be replaced.....

1 Message

July 17th, 2006 19:00

I had the same problem until I adjusted the focus to the point that the lense fell out. when I put it back in it worked. Maybe the lense was knocked goofy in shipping.   I did notice that when I use the zoom lever that it can not be focused. only one combination of zoom and focus will work. All else is determined by projector location.

 

good luck!

4 Posts

July 17th, 2006 19:00

I figured it out. If you want crystal clear quality use a monitor cable. The Svideo cable just doesn't cut it. Thanks for the help.

 

 

August 8th, 2006 23:00

Kris,
 
To see the max resolution your are going tto have to use the computer input on the projector.
 
The svideo is only going to show 800X600 max and that will depend on the source signal
 
Any questions you can email me at newageav@newageav.com ask for george
No Events found!

Top