1 Rookie
•
3 Posts
0
100
March 6th, 2025 02:30
Dell Precision 5570 Doesn't boot into Windows
I have a Precision 5570 bios sees my disk, but it doesn't see it when trying to boot. This happened after I got a BSOD for inaccessible boot device. I got into the recovery menu, and restored to the last restore point. That did not work. None of the other troubleshooting works either. It now won't recognize any m.2 drives after bios. I know the disk is good, because it will load and run fine on my other laptop. I even tried a blank m.2 with a windows install usb, the only disk shown is the usb. Diskpart from cmd prompt through recovery menu doesn't see the drive either. Bios is up to date.
Any help?
No Events found!
Chino de Oro
9 Legend
•
8.1K Posts
0
March 6th, 2025 15:33
If changing between RAID and non-RAID in BIOS settings can not resolve the issue, you may have to perform Windows installation again.
Download and extract Intel RST driver to load during Windows installation will make all drive visible.
mpboothe
1 Rookie
•
3 Posts
0
March 7th, 2025 07:18
@Chino de Oro Thanks. That let me fresh install onto a new drive. I still would like to figure out what is causing the original drive to give the sod for inaccessible boot device on the the Precision, but works fine on in my other laptop. Changing out of raid did not help. On a side note , I can access it as the second drive, just can't get it to boot.
mpboothe
1 Rookie
•
3 Posts
0
March 8th, 2025 18:41
@Chino de Oro I was able to get the disk to boot finally. I booted from the old laptop that doesn't use Raid. I then used dsim to inject the driver you pointed me to. I put it back in my Dell, and it worked like it should. Thank you for pointing me in the right direction.
Chino de Oro
9 Legend
•
8.1K Posts
0
March 8th, 2025 19:54
Glad to hear that the issue was resolved.