This post is more than 5 years old
2 Posts
0
44271
September 24th, 2014 10:00
MD3000 Raid Controller Module Memory Parity Error
MD3000 has two controllers. One of the controller failed. SO I replaced it with an used, but working controller. All errors are gone, except one "RAID Controller Module Memory Consistency Error".
Recovery Guru recommends steps which I followed without luck.
Looking for help in this forum.
Paul
DELL-Sam L
Moderator
•
7.9K Posts
0
September 24th, 2014 14:00
Hello Paul,
What you may need to do is on the replacement controller to pull the raid battery and wait about 2 minutes then reinsert it again. Also what I would try to do is to flash the firmware on the system as well.
Please let us know if you have any other questions.
pwentland
2 Posts
0
September 25th, 2014 15:00
Hi Sam,
Just the battery step didn't help. After I flashed the firmware on the system, the error was gone.
Thanks for your help.
DELL-Sam L
Moderator
•
7.9K Posts
0
September 26th, 2014 06:00
Hello Paul,
Glad that flashing the firmware resolved your issue.
Please let us know if you have any other questions.