Unsolved
This post is more than 5 years old
31 Posts
0
3593
November 7th, 2012 03:00
Help with power path and AIX
Hello,
I have an AIX server that connected via boot from san to CX4. now it's work with MPIO but i want to install and work with PopwerPath.
what is the best procedure to do it?
No Events found!
Avinash V
91 Posts
0
November 7th, 2012 04:00
Hi Jean,
You may refer to the Installation guide available at
Refer to Chapter - 3 (configuring a powrpath boot device on aix)
https://support.emc.com/docu32216_PowerPath_for_AIX_5.5_Installation_and_Administration_Guide.pdf
Ensure that the Failover mode on clariion is set to 3 or 4
You would have to uninstall EMC.CLARiiON.fcp.MPIO.rte and install EMC.CLARiiON.aix.rte
Since this is boot from SAN - ensure you refer to section "PowerPath and the bosboot tool"