1 Rookie
•
4 Posts
0
47
September 19th, 2024 04:49
Dell PowerEdge FN 410T Internal port speed
Hello!
There are two network modules on the FX2s chassis.
Dell PowerEdge FN 410T IOM A1
Dell PowerEdge FN 410T IOM A2
The module is running in "full switch" mode
I have the following problem:
In module A1, the Te 0/8 internal port is running at 1G speed, but I need it to run at 10G speed.
In module A2 the speed on this port is 10G.
This problem only affects one of the PowerEdge FC430 servers.
What was done:
I tried changing the speed of the internal port both on the server and on the module in slot A1, when I set the speed to 10G the port goes to "Down" state.
Could you please tell me what could cause this problem?
No Events found!
DELL-Erman O
Moderator
•
2.8K Posts
0
September 19th, 2024 09:06
Hello,
First, make sure you have the right SFP+ transceiver plugged into the Te 0/8 port. It needs to support 10G speeds. If you use a 1G transceiver, the port will only work at 1G speeds. Also, if you’re using longer cables, go for higher-quality ones that can handle 10G speeds. To set up the port, you can use the command
interface tengigabitethernet 0/8You can review this document Dell PowerEdge FN I/O Module Installation Guide
Hope that helps!