MD1420 connected to an R640 warns about something... unknown:)

Hi!

So i have this MD1420 enclosure that has worked fine for 7+ years, but it has run out of service now. However i still want to use it a bit for something else, so i moved the H830 raid controller from the server it was connected to (an R630), and connected it to another R640.

It seems to work fine, but the DRAC complains about something.

The enclosure was in Degraded state, until i finally connected the second power cord:) And now it says state=Ready, but still "status" is Warning...

Yesterday i upgraded the DRAC firmware, and also connected a second SAS cable (redundancy path restored...), but stupidly enough i did this kinda at the same time:)

It became OK for a while, but went back to Warning after a while...

All disks are "green", everything seems to work, but why the Warning? How can i get more info about that?

Some racadm output below...

racadm>>racadm storage get enclosures -o                
Enclosure.Internal.0-1:RAID.Integrated.1-1
   State                            = Ready                                    
   Status                           = Ok                                       
   DeviceDescription                = Backplane 1 on Connector 0 of Integrated RAID Controller 1
   RollupStatus                     = Ok                                       
   Name                             = BP14G+ 0:1                               
   BayId                            = 1                                        
   FirmwareVersion                  = 4.04                                     
   SasAddress                       = 0x3D08466026DB5C00                       
   SlotCount                        = 8                                        
   PciExpressGeneration             = Not Applicable                           
Enclosure.External.0-0:RAID.Slot.1-1
   State                            = Ready                                    
   Status                           = Warning                                  
   DeviceDescription                = Enclosure 0 on Connector 0 of RAID Controller in Slot 1
   RollupStatus                     = Warning                                  
   Name                             = MD1420 0:0                               
   EnclosurePosition                = 0                                        
   ConnectedPort                    = 0                                        
   FirmwareVersion                  = 1.07                                     
   ServiceTag                       = DPM...                                
   AssetTag                         =                                          
   AssetName                        = MD1420                                   
   RedundantPath                    = Present                                  
   SasAddress                       = 0x520474729A12CB7D                       
   SlotCount                        = 24                                       
   PciExpressGeneration             = Not Applicable               

racadm>>racadm raid get controllers -o -p rollupstatus
RAID.Integrated.1-1
   RollupStatus                     = Ok                                       
RAID.Slot.1-1
   RollupStatus                     = Warning                                  
AHCI.Embedded.1-1
   RollupStatus                     = Unknown